Teledyne 300m Bedienungsanleitung PDF herunterladen (Seite 72)

Teledyne API Model 300M CO Analyzer Instruction Manual, 04033, Rev. A

7.3 Status/Control

This subset of messages is concerned with reporting the status of the analyzer and controlling the

analyzer remotely. Whenever the analyzer does a calibration it issues a report to the RS-232

output. The table on the following page summarizes the status reports.

Table 7-4: Status Reports

Report

"C DDD:HH:MM IIII START ZERO CALIBRATION"

"C DDD:HH:MM IIII FINISH ZERO CALIBRATION"

"C DDD:HH:MM IIII START SPAN CALIBRATION"

"C DDD:HH:MM IIII FINISH SPAN CALIBRATION"

"C DDD:HH:MM IIII START MULTI-POINT CALIBRATION"

"C DDD:HH:MM IIII FINISH MULTI-POINT CALIBRATION"

"C DDD:HH:MM IIII START CALIBRATION HOLD"

"C DDD:HH:MM IIII FINISH CALIBRATION HOLD"

To do a remote adjustment via the RS-232 interface, the host computer should issue a message

with the following format:

C COMMAND<CRLF>

The commands are summarized in Table 7-5.

7-6

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 122 123

Keine Kommentare

Teledyne 300m Bedienungsanleitung Seite 72